Description

Designed to accompany our Drive by Wire Adaptors for JZA161 / Aristo (1997-2005), this adaptor piece enables a universal Bosch DBW Accelerator Pedal assembly (PN:0 280 755 051) to be bolted in place of the original cable drive pedal assembly using existing bolt holes.

No drilling needed!

CNC machined from 6061 aluminium; the bracket is designed to replicate the original pedal location and feel.

Fitment

Available only in RHD version at this time to suit the JZS161 Chassis.

Finish

6061 Billet Aluminium - Black Anodised

Included

• 1x CNC'd Bosch to JZA80/MkIV Bracket - Black Anodised

• 7x M6 316 Grade Stainless Bolts

• 7x M6 316 Grade Stainless Washers

• 1x Genuine Bosch DBW Pedal (Note: this is Optional)

• 1x Connector/Pin Set (Note: this is Optional on the RHD Adaptor)

Installation Tips

1. Contortion self under the dash to remove the OEM Throttle Cable and Pedal as per the Toyota Repair Manual (TRM)

2. Whilst still stuck under the dash, loosely install the upper two (2) M6 bolts with washers, followed by the lower bolt/washer through the bracket last. The upper bolt holes are slotted to provide ease of installation. Some fiddling with the firewall blanket may be required to move it up and out of the way, but no cutting is required.

3. Tighten down the adaptor bracket to the firewall.

4. Install the Bosch Pedal Assembly; it may pay to have already plugged in the harness (plug optional), as the space behind the dash is tight.

5. Complete wiring and tuning of the pedal, and install the Throttle Body Adaptor (sold separately) on the engine. An aftermarket ECU with DBW capability is required to control the pedal.