Description

Venom Automotive 1UZ-FE, 2UZ-FE & 3UZ-FE VVTi Variant Drive By Wire (DBW) Throttle Body Adaptor was specifically designed to mount a Bosch 82mm (PN: 0 280 750 473 - Not Included) to the VVTi OEM Intake Manifold to enable a host of benefits when paired with an aftermarket ECU such as:

1. Tidy up the Engine Bay by deleting Throttle Cable

2. Increased Tuneability and Idle Control

3. Launch control capability

This bracket is reversible to suit chassis or aftermarket fuel line configurations, as shown in the photos.

An O-ring seal is included to mount the throttle body; however, the design retains an OE gasket (22271-50042 - not included) for the blown injector port block off and intake air guide.

An optional Throttle Body Coolant By-pass block off plate kit is also available. Note: Installation of the DBW Throttle Body will require plugging the coolant lines on either side.

Requires the use of aftermarket ECU and E-throttle pedal. 

Finish

CNC Billet 6061 Aluminium - Black Anodised

Included

• 1x Billet DBW Adaptor to suit 1UZ-FE VVTi, 2UZ-FE VVTi or 3UZ-FE VVTi

• 4x M8 Grade 316 SS Bolts

• 4x M6 Grade 316 SS Bolts

• 4x M6 Grade 316 SS Washers

• 1x O-Ring

Installation Tips

1. Remove OEM Throttle Body.

2. Remove existing manifold studs with Vice Clamps in an anti-clockwise direction.

3. Ensuring the OEM Gasket is correctly positioned, install the Adaptor Plate.

4. Ensuring the 2mm O-ring is correctly seated, Install a Bosch 82mm DBW Adaptor.

5. Complete Wiring Installation - Refer Bosch Installation Instruction (not supplied).

6. Reinstall Intercooler Piping - Additional lengths or bends will be required as this throttle body is shorter than the OEM Variant.